Jump to content
Sign in to follow this  

gasket, o-ring question

Recommended Posts

I am doing my first top end and I am going to start putting things back together. So far it has gone pretty smooth. My question is do I need to do anything to the gaskets and o-rings to get them to seal good? The last thing I want is to get everything back together and have something not seal up. I know the manual recommends lithium grease to the o-rings. Anything else I should do?

Share this post


Link to post
Share on other sites

Just make sure everything is clean then torqued down to specs and you should be good.

Share this post


Link to post
Share on other sites
I am doing my first top end and I am going to start putting things back together. So far it has gone pretty smooth. My question is do I need to do anything to the gaskets and o-rings to get them to seal good? The last thing I want is to get everything back together and have something not seal up. I know the manual recommends lithium grease to the o-rings. Anything else I should do?

that's it, make sure base gasket surfaces are clean too.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×