Jump to content
Sign in to follow this  

07 WR250 Chain

Recommended Posts

I was somewhat disappointed to see that the chain on my 07 WR 250, does not have a master link. I already have an old chain breaker, and if it's not up to the job, a hand held grinder will be. Evidently using a link to reconnect the chain would require a press and riveter? In the past I have used vise grips with a small nut to press the plate over the pin, but the very little amount of riveting I have done involved a ball peen hammer. I don't care to spend $50-60 on tools that I won't need often. The chain is an O ring, 520 I'm assuming, but pin size and width might not be common. Anyone run into this and if so what have you done? Thanks Ron

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×