Jump to content
Sign in to follow this  

Looking for Turn Signal Electrical Connectors

Recommended Posts

I am changing out the large factory signals to smaller aftermarket turn signals.

This will be a non-LED signal.

I am looking for the male connector that is on the factory signal so I can adapt them to the new signal.

Last resort is to cut them off the factory signal. I am trying to get around that option.

The Motrax jumpers I purchased for this type of conversion has the wrong connector. They are triangular in shape.

I need the small radiused rectangular connector found on a 2007 DR650.

Any replies are appreciated.

Share this post


Link to post
Share on other sites

I replaced them at either end.

Sarah

Share this post


Link to post
Share on other sites

Just replace them with the simple bullet connectors that pretty much all aftermarket turn signal comes with. Even if you sell the bike you can just put the same connector on the originals to convert it back to stock.

The adapters just add an unnecessary connection and additional wire that will look messy and you have to put somewhere. KISS, especially when it comes to electrics!

Share this post


Link to post
Share on other sites

Thanks for the replies.

I was looking for plug and play but the bullet connectors keeps it simple.

withiam

Share this post


Link to post
Share on other sites

Don't forget heatshrink, or liquid electrical tape, and dielectric grease.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×