Jump to content
Sign in to follow this  

Issues with Linkage Bearing Install

Recommended Posts

After pressing in new bearings, then when sliding the collars in they hang up on the opposite side bearings like something isn't aligned right. This has happened on every one.

Has anyone else ran into this? :moon:

Share this post


Link to post
Share on other sites

Are both the needle bearings seated in the linkage the same amount? Does it do the same thing from both sides?

Share this post


Link to post
Share on other sites
Are both the needle bearings seated in the linkage the same amount? Does it do the same thing from both sides?

Yes and Yes

Share this post


Link to post
Share on other sites

If the bushing will slide into each bearing individually, try turning the pin as you push it in. Give each side a full rotation or two to get all the little pins in their places. I have had trouble as well when is packed as much grease in them as possible.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...