Jump to content
Sign in to follow this  

graphics on new plastics

Recommended Posts

just put soapy water on the plastics. then wipe it off. then put soapy water back on it and stick then squeegie out water. did it today

Share this post


Link to post
Share on other sites
just put soapy water on the plastics. then wipe it off. then put soapy water back on it and stick then squeegie out water. did it today

I do the same thing!

Share this post


Link to post
Share on other sites

I clean them thoroughly with hot soapy water, and then rubbing alcohol. Even though they look clean, new plastic often have oil residue on them from the molding process.

Share this post


Link to post
Share on other sites

I always use 200 grit sand paper where the graphics go, to give the glue a good bonding surface. After I scratch up the area I clean it with alcohol. I would never think about putting graphics on smooth uncleaned plastic, just my preference.

MAX!!!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×