Jump to content
Sign in to follow this  

Sxc625

Recommended Posts

My bike has a HSR42 Mikuni. I need some help rebuilding the carb. The pin that holds the float in appears to be a press fit. Is there a special tool to remove this pin

Share this post


Link to post
Share on other sites

If I remember correctly the float pin is lightly pressed into one side only, you have to figure out which it is so as to not have to push the whole pin thru the tight side. I think I used a small size (6mm?) 1/4 drive deep socket to back up the float pin perch and a small drift punch to drive it out. Shouldn't take much force.

1bd

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...