Mad Moose Posted March 29, 2010 The MIL light on my bike started flashing today but it seems to be running just fine. I don't have my manual with me and i'm not even sure if the MIL codes are even covered in the standard operating manual. Anyways, the code sequence is 9 consecutive flashes. Anybody know what it's trying to tell me? Thanks Share this post Link to post Share on other sites
crawfishoo Posted March 29, 2010 IAT sensor is unplugged! Its the air temperature sensor in the airbox. All of the MIL information, codes, and diagrams are pages 7-9 in your manual. Share this post Link to post Share on other sites
Mad Moose Posted March 29, 2010 sweet, thanks for looking that up for me. must've not pushed it in all the way when i removed the subframe. Share this post Link to post Share on other sites
119as350 Posted September 25, 2015 I have 9 flashes on my kill switch also on my 2010. I cleaned the IAT sensor and ensured the connection was good, still flashing. Any other suggestions?? Share this post Link to post Share on other sites
119as350 Posted September 26, 2015 Update: thanks to the great info I have found on this site, I pulled the wires out of the connecter, put a piece of paper in between the male ends to keep the wires from touching and attached them directly the female wires without the connector, fired it up and no more flashing light. Share this post Link to post Share on other sites
