HappyG My Rides (8) Posted April 10, 2010 as above, what do you need to remove and/or jump to remove the extra stuff? thanks Share this post Link to post Share on other sites
daleCarlsbad My Ride Posted April 10, 2010 Just trace the wires from the clutch lever down to where they plug into the wiring harness, unclip them, and then cut the clip off of the harness and splice the two wires together (to complete the electrical circuit). Takes all of 2-minutes..............👍 Share this post Link to post Share on other sites
HappyG My Rides (8) Posted April 11, 2010 Just trace the wires from the clutch lever down to where they plug into the wiring harness, unclip them, and then cut the clip off of the harness and splice the two wires together (to complete the electrical circuit). Takes all of 2-minutes..............👍 ok so the clutch is a normally closed switch, easy. how about the neutral safety switch? Share this post Link to post Share on other sites
RiDeCuStOm Posted April 11, 2010 just a question, why would you want to do this? Share this post Link to post Share on other sites
HappyG My Rides (8) Posted April 11, 2010 Clean everything up, eliminate unnecessary wiring, none of my bike have ever had these, so I really don’t need them. Share this post Link to post Share on other sites
