Hey guys, I installed the Tusk Enduro Light kit from Rocky Mtn. MC last week. Today I was hoping to clean up the install a bit and wire the light kit on-off switch to the bike main switch. So I spliced the wires into the Red and Brown for the switch, which per the service manual wiring diagram would be correct. My results were less than successful. I blew the 10A fuse, and the taillight would not shut off. I really don't like having that On-Off switch on my bars because it's getting crowded up there. I wanted to simplify it a bit, and remove my stupid factor (I could easily see myself leaving that switch on and killing 3-4 batteries a year). I thought it'd be simple, but it definitely has me stumped. I fugured that I may need to put in a 15 or 20A fuse to handle the load, but the taillight staying on has me really scratching my head. Anyone got any ideas on how I can make this work?