I am pretty sure this has been on here before but I searched and couldn't find it. There is a plastic shield below the gas tank and directly above the valve cover spark plug area. The manual simply refers to it as a cover and gives no instructions on how to remove. There are two plastic pins at the back that hold it on. From the diagram in the book it appears like they just "snap" in. This apparently isnt the case as I managed to break one while removing. Anybody know the right way for removing these? I am going to buy a couple of extra for future use as you can not get to the spark plug without removing this cover. Grey, this might be a good procedure to put in a sticky for the 2010/2011 bikes. Hopefully it will prevent future owners from making the same mistake.