Jump to content
Sign in to follow this  

Tusk handle bar risers. Xr650 stock cables.

Recommended Posts

I have these and the stock cables work fine. Says 3/4 inch rise.

http://www.rockymountainatvmc.com/productDetail.do?navType=type&webTypeId=241&navTitle=Handlebars-Control&webCatId=12&prodFamilyId=3154

But I'm interested in these because they claim to raise bar 1.2 inches.

http://www.rockymountainatvmc.com/productDetail.do?navType=type&webTypeId=241&navTitle=Handlebars-Control&webCatId=12&prodFamilyId=25849

Anyone tried these? Work with high bars and stock cables?

thanks

Share this post


Link to post
Share on other sites

I use the Pro-taper adapters for my RC High-bend Renthal Fatbars and my stock cables are stretched to the limit.....I guess the only thing you can do is look at your current setup at full lock both ways and see if your cables look like they have another 3/4" of slack to account for the difference between the rise of the Tusk products.

Share this post


Link to post
Share on other sites

DSCF0081Rsolutiondelcran.jpg

same configuration as the fellow before... and yes stretch to the limit, but it works. You really have to reroute them perfectly to make it work but it is all working flawlessly for me. And the stand up riding is now a blast, and I'm 6.1 foot.

:cheers:

Share this post


Link to post
Share on other sites
I have these and the stock cables work fine. Says 3/4 inch rise.

http://www.rockymountainatvmc.com/productDetail.do?navType=type&webTypeId=241&navTitle=Handlebars-Control&webCatId=12&prodFamilyId=3154

But I'm interested in these because they claim to raise bar 1.2 inches.

http://www.rockymountainatvmc.com/productDetail.do?navType=type&webTypeId=241&navTitle=Handlebars-Control&webCatId=12&prodFamilyId=25849

Anyone tried these? Work with high bars and stock cables?

thanks

I have the 1.2" tusk risers on my xr650l, without high bars, so my cables fit fine. what i did want to warn you about is that the risers had to be reamed out about 1/16". the bolts holes, (center to center) were at least 1/16 inch too short on each riser hole, so all 4 needed lengthened. with just a drill and a dremel, it tool a while.

Share this post


Link to post
Share on other sites

a>

just fixed one on my bikes...more comfortable handling fer sure!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×