Hyde Sump Guard

Just got through the post a Hyde plastic sump guard , now im running a full Yosi RS2. Now the guard fits tight around the lower frame rail and around the engine cases but the lower part of the down pipe is touching the guard :confused: this will not take long to melt :worthy: if i put on another exhaust gasket this then should space the lower part of the exhaust out enough to clear the guard and stop the guard melting.

Has anyone else had this problem ?

:thumbsup:

Save your self the headache,,, relieve the area around the header for an air gap of 5mm or so.

I was not concerned with the finish of my header... so I just installed the Hyde plate, rode the bike for 20 min, came in, removed plate, and trimmed off the melted parts :thumbsup: perfectly clearanced now..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now