Jump to content
Sign in to follow this  

Wiring a brake-light pressure switch...

Recommended Posts

Need a little help. I purchased a brake light pressure switch for my 300 EXC. Pulled off the seat and rear light assembly and realized that the bike comes almost ready for brake light hook-up. (already has 3 wires going from plug near gast tank back to bulb and bulb is already the correct one for running lights/stop light).

My question is, I can see the green/white wire is already in the plug and I know that one end of my pressure switch will plug into that, but which wire on the supply end do I jump power from? The white one or the brown one?

Share this post


Link to post
Share on other sites

That was my assumption. thanks. I would crank it up and just check with a tester, but the bike is apart and not in a state to be started.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×