Jump to content
Sign in to follow this  

Mikuni manifold tt500

Recommended Posts

Does anyone know the Mikuni manfiold part number for 36mm carb for tt500.

I have a Mikuni manifold from ThumperStuff where the screw holes are 8mm and the cylinder head screws on standard 6mm. The manifold moves all around in the slopy holes?

Share this post


Link to post
Share on other sites

Nope..Why not just make up some sleeves to fit in the holes out of the correct sized copper/brass or metal tubing..Plumbing type shop may have some,,.

Share this post


Link to post
Share on other sites
Nope..Why not just make up some sleeves to fit in the holes out of the correct sized copper/brass or metal tubing..Plumbing type shop may have some,,.

Ggood idea but I was wondering if this is normal?

I'll take you advise

R

Share this post


Link to post
Share on other sites
anyone make one that is angled (to straighten carb)? is yours angled?

Don't think I have ever seen one angled. I would think it would make the air flow little turblent.

Share this post


Link to post
Share on other sites

there was one (alum.)on e-bay that was angled just a little. whitebrothers used to cut the whole intake out and weld in a new intake tube. must have changed the angle also.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×