DIY sag setting tool

Hey guys, I made this "tool" to set my race sag by myself. Thought I'd share it for those who may be searching for a way.

All I did was take an old rod and reel and cut the rod just below one of the eyelets that will fit about half way into the axle hole. Mark fender and remove a couple eyelets around the fender area to give enough room, then just duct tape the bottom in place and use small zip-ties to mark the the different sags. I put a few zip ties on ahead of time and leave them slightly loose so I can move them down the rod and then tighten.

Not a perfect solution buts beats the hell out of trying to read the tape yourself or trying to get the wife to read the tape measure. :smirk:

:smirk:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now