Jump to content
Sign in to follow this  

Is the Gear shift position sensor needed?

Recommended Posts

Hello,

I just noted that the Gear shift position sensor cable was broken of the unit.

Is the sensor needed?

Does anyone know if it's possible to solder the cable back to the GPS unit?

Is it difficult to dismount and reassemble it?

Thanks

Share this post


Link to post
Share on other sites

It is easy to remove and the cable can be soldered or repaired with an electrical connector.

Share this post


Link to post
Share on other sites

Will I have to drain the engin from oil before removing the sensor?

Share this post


Link to post
Share on other sites

Not if you lean her over, handlebar on your bikestand style:thumbsup:.

Share this post


Link to post
Share on other sites

Important to run it. I believe it might modify the ignition curve. I remember reading a baja bike blew up and they think it was from the GPS being unplugged.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×