Jump to content
Sign in to follow this  

kickstand mod

Recommended Posts

I started with grinding out the partially covered hole on the bottom, moved on to drilling 3 holes in the support/brace connected to the bottom plate. Picked appropriate size drills (small,med,large) don't go to big or the brace may collapse. This mod was done to remove weight at the of the stand. To finish off the changes I removed 1/8 inch off the upper stand stop. Together I believe less end weight and having a slightly higher retracted stand I feel that going over jumps I don't have the stand bouncing up and down. I don't have the stand switch installed but if you do and use your z in the dirt this mod may help with the intermittent cut outs.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...