Jump to content
Sign in to follow this  

Repacking a FMF Turbine Core 2.....

Recommended Posts

Well I pulled the screws out and pulled the silencer apart and removed the old pack. However looking at the cone end of the silencer there is a lot of carbon and gunk built up in it. So do I just drill out all the other rivets and pull this part out?

Or is there another way to clean it out without going through that hassle? I assume if there wasn't then FMF would have put screws on that end too.

Share this post


Link to post
Share on other sites

I've done it two ways. Easiest is when I had a sandblaster available to me, it got a lot of it very clean with minimal work.

I've also just let it soak in gas. Not perfect, but it does take some of the residue off.

Share this post


Link to post
Share on other sites

I wouldn't mess with the rivets and instead just some elbow grease with a wire brush.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...