Jump to content
Sign in to follow this  

1984 CR250R - Trouble getting it started

Recommended Posts

So I have a 1984 CR250r and I can't get the bike to start. It hasn't been run in about 5 years. The engine was rebuilt, but in pieces when I bought it. Here is the things I have done so far.

I cleaned the carb.

I checked and have a blue spark.

I replaced the CDI with a used one.

I replaced the kill-switch with a new one.

I replaced the ignition coil with used one from a 84' CR500. The tolerances are the same as the CR250. I am getting spark with the original coil, but its much weaker. I have switched them around and it still wont start.

I have cleaned all the contacts and the grounds.

I replaced the stator with a used one from a 1985 CR250r.

I used new plugs and made sure to gap them.

I have tried using stating fluid.

I have double checked everything. Any advice would be helpful. Thanks

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this