Jump to content
Sign in to follow this  

re tightening Retainer screws (kickstart install)..

Recommended Posts

I got them out okay but they are a little beat up from the impact hammer removal.So I intend on replacing them but my question is when i re install them do i use the impact hammer again to retighten them? or do i just hand tighten them? They were really tight from the factory. Also should i loctite them in?

Share this post


Link to post
Share on other sites

please use new ones. I buggered mine up and then installed them again....when I went to take the kickstart kit off to sell it, even the impact driver didn't work and I had to drill them out

Share this post


Link to post
Share on other sites

I found replacements at my local hardware store, with allen heads to replace the phillips. Hand tighten!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×