Jump to content
Sign in to follow this  

XR75/100 intake manifold question

Recommended Posts

I recently restored a 1976 Honda XR75 but decided to put a 2000 XR100R engine on it to get as much power as I could out of it. I saw on here where going to a 30mm carburetor would greatly increase the horsepower so I bought one which came in today. My problem is I only have the stock intake manifold which is much smaller. My question is could I get a dremel tool and bore that manifold out to a 30mm or close? Or could someone tell me where I could buy a 30mm intake manifold that would fit on a 2000 xr100 engine. I saw a couple of ebay but they were for CRF would that work? Any help would be appreciated. Thanks Scotty.

PS I had the bike listed for sale on here if you need to take a look at it. Should be in the classified

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...