Jump to content
Sign in to follow this  

Valve Clearance?

Recommended Posts

I'm getting ready to check the valves on my 09 and after looking up the tolerances I'm mixed up.

The tolerances listed on Team Green's website are,

intake- .17 - .22 mm

exhaust- .10 - .15 mm

I also searched some threads on here and found the same numbers, but switched. (intake .10 - .15 mm and exhaust .17 - .22mm)

Can anyone set me straight on this?

Share this post


Link to post
Share on other sites

Not sure were your seeing that. Team green says this:

intake i know is always the tighter spec

Intake - (.004 to .006) or metric (.17 to .22)

Exhaust - (.007 to .009) or metric (.1 to .15)

Edited by spin05

Share this post


Link to post
Share on other sites

Both are wrong.

The intake is .10 - .15 mm

The exhaust is .17 - .22 mm

I'm 100% certain. The Team Green instructions have the info mixed up.

Share this post


Link to post
Share on other sites

Both are wrong.

The intake is .10 - .15 mm

The exhaust is .17 - .22 mm

I'm 100% certain. The Team Green instructions have the info mixed up.

Yes you are correct .Atleast as far as the Millimeter callout. The u.s. inch callout is correct. I use that anyway. So didnt notice the millimeter being reversed.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...