Jump to content
Sign in to follow this  

2000 Honda CR 250 w/ Rekluse Z-Start Pro question

Recommended Posts

I just installed the Rekluse Z-Start Pro today, but the complete install has been stalled due to the wrong thick gasket in the box. I have the bike buttoned up until the gasket comes, so I can finish the set-up. What I noticed was when I pulled the bike off of the floor and pushed it forward and it makes a slight clunk sound. It also slightly clunked when I pushed it backwards. Is this normal? Then again I do not have the clutch cable hooked up, per instruction. I suppose I am worrying, because this is such a different install compared to a new top end, clutch, etc.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...