Jump to content
Sign in to follow this  

What's the trick to undoing those pesky 2 carb electrical connections on the yz250 carb?

Recommended Posts

I dread rejetting everytime I have to take off the carb cus of these 2 stupid connections. I try to dig a lil screwdriver into the side prong things and pull down but it just chews up the nubs. Are my fingers just to fat or am I missing something here? I'm talking about the tps and solenoid connections....any tips guys?

Share this post


Link to post
Share on other sites

-First, wash the bike and blow the fittings out with compressed air.

-Push the connector together (very hard) like you're plugging them in and then press the release button.

-Now, still holding the releasebutton, pull them apart by the plastic housings (not by the wires).

If they get full of dirt/silt/sand/mud/etc they will jam up and be very hard to disconnect.

A little water followed by some compressed air can help flush out the crud.

Share this post


Link to post
Share on other sites

Same way I do it but I still use a small screwdriver on the tab and push and pull them apart

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...