Jump to content
Sign in to follow this  

Dunlop D952 120/90-19 Clearance with a Pro Moto Billet kickstand?

Recommended Posts

I was just wondering if anybody here is or has run a Dunlop D952 rear (120/90-19) on a YZ250 with a Pro Moto Billet kickstand installed?

I currently have a MX31 (120/80-19) installed and it's a very close fit so I'm just a bit worried about going up slightly in both diameter and width.

Thanks!

Edited by NVarra

Share this post


Link to post
Share on other sites

Hi mate

I have one on my cr500 and the end of the stand arm hung out over the tyre.

What i did was to fit a few washers (2-3) between the stand and frame at the top bolt.

This has the effect of tilting the top of the stand out and bringing the arm away from the tyre.

The down side is that it reduces the angle of the arm when its in the down position.

ie the bike is in a more upright position.

cheers

Share this post


Link to post
Share on other sites

That's a brilliant idea!

I was thinking I may have to heat it up and bend it, but shimming it is so much saner.

Hopefully she'll mount right up and have enough clearance, but if not shimming it will definitely take care of business.

Thanks for the tip Thermos. :bonk:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...