ca400rider

Members
  • Content count

    3
  • Joined

  • Last visited

Community Reputation

10 Good

About ca400rider

  • Rank
    TT Newbie

Profile Information

  • Location
    California
  • Interests
    So far, Pismo Dunes
  1. Suzuki

    Thanks again for the info Now I've got a new issue. I was removing the screws on the float bowl to put a new main jet in. Dam brass screws, I got three of the four out when the fourth one stipped. Now I'm stuck with the daunting task of trying to remove that fourth screw. It was too stripped by the time I tried an impact driver on it, only made it worse. So my next step is trying to cut lines in the screw head with a dremal tool so I can use a slotted screw driver to remove it. Wish me luck. If anyone has any tips about removing a stipped float bowl screw, it would be appreciated.
  2. Suzuki

    Thanks CT for the info. You said 3/4 to 7/8 of slack, where is that measured from, the middle of the swing arm?
  3. Suzuki

    I just changed to a 13 tooth sprocket, now the chain has a lot of slack in it and I lost my owner's manual. How do I adjust the tension in the chain and what's the proper amount of slack that should be in it. Thanks before hand for anyones help.