Jump to content

Redhooktn

Members
  • Content Count

    23
  • Joined

  • Last visited

About Redhooktn

  • Rank
    TT Newbie

Profile Information

  • Gender
    Male
  • Location
    Tennessee
  1. Redhooktn

    Where to buy fcr 39 float bowl?

    Try www.sudco.com
  2. Redhooktn

    Two Red Plates

    He has not taken it yet. Number of wins don't count right now. He will probably take it tonight but the fat lady ain't sang yet.
  3. Redhooktn

    Two Red Plates

    Red plate is for the points leader, season is not over and there is a tie. Tie breakers do not come into play. Let the champ share it
  4. No practice! If I can race 60 to 100 miles through the desert at break neck speed without practice or pre-running I think they can probably handle learning the track in the heat of battle.
  5. Redhooktn

    FCR 39 idles fine but dies off idle

    Thanks Stuwy and Throttle, runs like a champ!
  6. Redhooktn

    FCR 39 idles fine but dies off idle

    I will try that, will the extended screw I bought for my stock carb work in the FCR?
  7. Redhooktn

    FCR 39 idles fine but dies off idle

    Not yet, no time till Friday. But should it not at least rev when rolled on slowly?
  8. Redhooktn

    DRZSM ignition switch question.

    It is a Baja Designs switch, HDB modifies the clamp for it. I have seen one mounted like yours, maybe even yours, on here. Looks clean.
  9. Redhooktn

    FCR 39 idles fine but dies off idle

    Nobody? Where are the FCR guru's?
  10. Redhooktn

    DRZSM ignition switch question.

    HDB clamp with Baja Designs switch, vapor mount and hand guards, all the lights worked the first time! Unfortunately they no longer offer anodizing for the hand guards.
  11. Redhooktn

    DRZSM ignition switch question.

    So I did it and it works!
  12. So I bought a used slant from a running bike, supposedly, and rebuilt it. No carb cleaner and not my first rebuild. Fired right up and idles fine at around 1800 rpm, crack the throttle and it dies, roll the throttle and it dies. Turn the idle screw and the idle tops out about 2200 with out dying. Bike has a new MRD, 3x3 and a new foam air cleaner. Jetting is MJ 155, PJ 45, Main Air 200, Pilot 100, clip in third, needle type unknown, Fuel screw 2.5 turns out. Pump diaphragm rod is a little longer than stock but not much. I can't pull it off till next weekend but an ideas or advice as to what to look for would be greatly appreciated.
  13. Redhooktn

    DRZSM ignition switch question.

    I'm going with HDB hand-guards and top clamp and I need to change my ignition switch to make it all work. A two wire switch is all that will work for my mods. After looking at the wiring schematics I believe that the black and blue wires do not need to be switched and can be soldered together leaving the red and orange wires to be switched. Has anyone out there done this or have any knowledge of it being done? I don't need the parking position on the switch. Thanks ahead of time for any help!
×