Jump to content

Crazyclown

Members
  • Content Count

    24
  • Joined

  • Last visited

About Crazyclown

  • Rank
    TT Newbie

Profile Information

  • Location
    Alberta
  1. Crazyclown

    Carburetor/jetting

    Ok thanks. So my bike runs good other than when I snap it wide open it hesitates for a split second. So I bought the bike used, and the previous owner put a bigger cam in, so would that change my jet sizes?
  2. Crazyclown

    Carburetor/jetting

    It's an 08 yz450f. Ok but the idle doesn't change when I adjust the red one, the one I'm pointing at I think might be the air fuel ratio screw but I just wanted it confirmed. I have a service manuel, but it wasn't clear enough about it.
  3. Crazyclown

    Carburetor/jetting

    Here's a video
  4. Hey, so I have been searching on here and I can't seem to find the answers I need, so I'm confused, I'm trying to jet my bike and I'm getting no where. So can somebody tell me which screw is which and what they adjust? Thank you.
  5. Crazyclown

    Yz450f dropped and won't start

    So my bike is smoking now tho, should I be worried about that?
  6. Crazyclown

    Yz450f dropped and won't start

    So I rechecked my my valve clearances and the one was 0.18 mm, so I fixed that and now the knocking is gone. So thanx for all the help.
  7. Crazyclown

    Yz450f dropped and won't start

    And if I replace the valves, can I just change the 2 exhaust valves or do I have to do them all? And what else should replace other than the valves themselves? And what's better titanium or steel valves?
  8. Crazyclown

    Yz450f dropped and won't start

    Thanks a lot for all the help so far. So I got my bike back together an running, but its making a loud knocking so I'm assuming I got bent valves (or no?) or is there maybe something else that could b wrong that would make that noise?
  9. Crazyclown

    Yz450f dropped and won't start

    Ok, so when I install my cam chain how do I make sure I didn't turn the flywheel with taking it apart? Or should it line itself up when I line up the timing chain?
  10. Crazyclown

    Yz450f dropped and won't start

    Sorry missed that lol. So is 11oz gonna b too heavy and I'm gonna loss power?
  11. Crazyclown

    Yz450f dropped and won't start

    What's a good weight to go with for the flywheel?
  12. Crazyclown

    Yz450f dropped and won't start

    Also I lv been reading a bunch of posts on here, and I read something about getting a different flywheel would help the bike from stalling as easy? Or did I read that all wrong?
  13. Crazyclown

    Yz450f dropped and won't start

    So do I need to do anything with the decomp setup or is that just out of timing because my exhaust cam is turned? Yea I figured out I need a flywheel puller, so what's the easiest way to get the nut off that's holding the flywheel? And I was trying to check if I bent a valve but couldn't really tell, so should I open the motor further and make sure I didn't bend any valves before putting it back together?
  14. Crazyclown

    Bigger cams valve clearances

    So all my valve clearances are .10mm exhaust and intake
  15. Crazyclown

    Bigger cams valve clearances

    Couldn't figure that out, thanx thi
×