Jump to content

Robbie Webb

Members
  • Content Count

    6
  • Joined

  • Last visited

About Robbie Webb

  • Rank
    TT Newbie

Profile Information

  • Location
    Kentucky

Recent Profile Visitors

28 profile views
  1. Robbie Webb

    Dripping water from small hole at bottom of motor

    Yeah did that just before the top end rebuild and push the bike home took me almost 2 hours back to the house and left my phone at home so wasn't no calling for a ride again thanks a lot for your guidance and ride it like you stole it!!!!
  2. Robbie Webb

    Dripping water from small hole at bottom of motor

    So let me ask this William 1 should I go ahead and purchase a rebuild kit for it or just a gasket and seals because I was just in the garage and it's leaking real bad now I'm only asking because this is my first fix it myself bike just did a big bore kit and I'm trying to get my ride time in and not hurt the top end so thanks for the feedback
  3. Why is my bike leaking water from the bottom of the motor and how would I know if my water pump is working
  4. Robbie Webb

    My first top end rebuild 2002 cr125

    Thanks again for the feed back and I got it together this afternoon and my bike fired up on the third kick and sounded good at a low idle so I shut it down an going to put everything back together in the morning
  5. Robbie Webb

    My first top end rebuild 2002 cr125

    Thanks for the feedback and I wish it was that simple this is my first time and I bought a cylinder that was already sleeved and it came cylinder only and the new wiseco piston ring so I'm using everything from my cylinder the next time I'll take it and have it done I just didn't have the time to do it so I ordered but as I said I have cold feet now that I have everything ready to go back to together
  6. I'm getting ready to start putting my top end back together I had to get a bored cylinder and wiesco piston and I'm getting cold feet because I keep reading about these exaust values and having to shave them down so that they don't stick out into the cylinder walls and damage the Piston I'm not to much of a fabricator and I've already got a little money in this rebuild my buddy says it is fine and I'm also using the old power Valve and assembly and I don't think my prep work is up to par should I take it to a shop or dig in and getter done
×