Jump to content

Yamahammer52

Members
  • Content Count

    25
  • Joined

  • Last visited

About Yamahammer52

  • Rank
    TT Member

Profile Information

  • Location
    Missouri

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Yamahammer52

    Will hit but not start

    Could it possibly be just a little out of time. Could the intake valves be opening a little sooner than they should?
  2. Yamahammer52

    Will hit but not start

    Rechecked float height and made sure carb was clean as a whistle. Bike started and ran for 4 or 5 seconds but sounds like bike has air leak sounds really weird. What could cause that?
  3. Yamahammer52

    Will hit but not start

    Well check out thanks
  4. Yamahammer52

    Will hit but not start

    Yes I have and it's the same thing. Run a couple seconds then die. What else could be the issue?
  5. Yamahammer52

    Will hit but not start

    Will do and will update with what I find out. Thanks.
  6. Yamahammer52

    Will hit but not start

    Just on a whim I checked the TPS for correct ohms did not get what book called for. Could a bad TPS cause my problem?
  7. Yamahammer52

    Will hit but not start

    Acts the same either way.
  8. Yamahammer52

    Will hit but not start

    Yes I could and I ran wire through all jets to make sure everything was clean.
  9. Yamahammer52

    Will hit but not start

    Yes I can. And I ran a small piece of wire through all jets and made sure all was clean.
  10. Yamahammer52

    Will hit but not start

    I checked the float height. It was good. I did not pay alot of attention to the float needle.
  11. Yamahammer52

    Will hit but not start

    Rechecked timing everything is good. Cleaned carb again went to start. Now back runs for 2 to 3 seconds then dies. Dose this every other kick mostly but sometimes every kick.
  12. Yamahammer52

    Subframe swap

    Trying to put ufo restyle plastic on 99 yz250. Dose any one know if a 2003 250f frame will bolt up and fit plastic? If not dose anyone know what modes I can do to make my subframe fit restyle plastic? Thanks any input is greatly appreciated.
  13. Yamahammer52

    Good woods bike?

    Hello I ride mainly woods and hare scrambles. Right now I am ridding a 2003 yz250. I have the chance to buy either a 2015 fc450 or a 2014 txc310r. Would like any insight on witch bike would be better and if any known problems of the 2. Thanks.
  14. Yamahammer52

    Will hit but not start

    Checked timing again. Everything is timed perfectly. All bike dose is hit not start and run. What else could be issue
  15. Yamahammer52

    Will hit but not start

    There are 2 marks on the flywheel which one do you go off of or do you put it between the 2?
×