Products > Electrical > Electrical Components > Stators & Coils > Accel Super Coil Kit - 2 Cylinder (One-Coil) - Inductive Discharge (140403S)
veh4 UNIVERSAL PRODUCT What does this mean?

Accel Super Coil Kit - 2 Cylinder (One-Coil) - Inductive Discharge (140403S)

Facebook Twitter

SKU: 140403S

RETAIL: $119.95
YOU SAVE: $12.00 (10%)


ACCEL engineers designed these coils special low-resistance primary winding to match the operating characteristics of factory and aftermarket CDI systems Maximum performance with fast rise times Faster rise time, increased spark energy and longer spark duration results in up to 45% higher voltage than O.E.M. coils Unique molded case with finned top prevents carbon tracking Bolt-on installation Manufacturers lifetime replacement warranty Using the wrong coil may damage your motorcycles electronic ignition module. To determine your ignition type, complete the following test: 1. Determine whether the type of coil you are replacing is a high tower coil. (These coils will NOT replace single tower coils.) 2. Using a volt meter or 12V test light, hook the positive lead to the positive post and the negative lead to the ground on one of the stock coils. 3. Turn the ignition on, but DO NOT engage the starter button. 4. If there are 12V at the coil, the motorcycle has an inductive type ignition. If there is no voltage at the coil, then the motorcycle has a CDI ignition because the power goes to the control box first. 4 Cylinder Model Two Coil Kit Inductive Discharge Ignition Primary Resistance is 3.0 Ohms Made in the USA Motorcycles with point or electronically triggered ignitions use PART #140403 or #140403S Bikes equipped with capacitive discharge ignition (CDI) use PART #140404 or #140404S Extra-heavy-duty 9mm silicone wires included
Stock photo shown, actual item may vary by model.

Add new paragraph   Close

While universal products are designed to fit a range of vehicles they may not fit all vehicles. If you are unsure of the fit we recommend posting a question on the ThumperTalk forums or contacting the manufacturer before ordering.