Products > Engine > Valve Train > Camshafts > S&S Cycle 570CE Easy Start Chain Drive Camshaft Kit (106-5296)

S&S Cycle 570CE Easy Start Chain Drive Camshaft Kit (106-5296)

Facebook Twitter

SKU: 106-5296


Convert your Twin Cam to a gear drive Kit includes cams, gears both inner and outer, gaskets, bearings, bolts and heavy-duty bearing plate How it works: Each of the 2 exhaust cam lobes are equipped with a spring loaded compression release lobe on the heel of the cam at the point where the valve would normally be fully closed. The lobe holds the exhaust valve open slightly at cranking speed. This releases some of the compression, making the engine much easier to crank. Once the engine starts, and rpm increases, the compression release lobe is centrifugally retracted and the engine runs normally, with full compression, and without any loss in performance. This allows a stock starter and battery to start nearly any engine. Start any engine with a stock starter Save your starter and battery Reliable-tested for 10,000 starts and didnt even run the battery down Automatic - no buttons to push Available in chain and gear drive versions Designed for 88in. to 95in. engines with compression ratios between 9:1 and 10:1 Intake Opening (degrees): 20 Intake Closing (degrees): 40 Exhaust Opening (degrees): 55 Exhaust Closing (degrees): 20 Intake Duration (degrees): 240 Exhaust Duration (degrees): 255 Valve Lift (in): .570 Intake Lift at TDC (in): .187 Exhaust Lift at TDC (in): .179


This product is labeled to fit with the following vehicles:
Stock photo shown, actual item may vary by model.

Add new paragraph   Close

While universal products are designed to fit a range of vehicles they may not fit all vehicles. If you are unsure of the fit we recommend posting a question on the ThumperTalk forums or contacting the manufacturer before ordering.