Search the Community: Showing results for tags 'friction plates'.
Found 2 results
After 70 hours on KX 100, I changed my daughters Friction Plates and Steel Plates. This is the first time doing this, and I was wondering by the look of the pictures if you can tell me if they needed to be changed or not? I haven't had a chance to measure them yet, but Just wondering in the future what I should be looking for.
Hey Thumper Talk community I've been all over the forums trying to find out what is going on with my 09 drz400sm clutch. So during the end last riding season I noticed my clutch lever started feeling poor. Just didn't give a very good feel but still functioned just fine. I thought the lever just needed to be adjusted. So in preparing for this up coming riding season here in Minnesota I started to adjust my clutch lever. No matter how I adjusted it at the lever/perch/cable area I could not get it dialed in. I then proceed to work on the clutch arm and see if that was the problem. From what I was reading the clutch throwout post needs to be rotated all the way counterclockwise, then the arm place in either the original position or parallel to the bike. I feel like I have tried every position and every time it leads little to no room in the cable to adjust it at the perch and wont fully disengage the transmission. The clutch lever has great feel but no slack in the line and will barely allow me to rotate the rear tire while the lever is in and in gear.(not fully disengaging) I started to think something inside the clutch was wrong even though it worked fine last season. I followed this clutch inspection guide and everything is in tolerance. I'm kind of stumped. I even tried to put everything back to how it was last season to see if i could get something but no luck. I have zeta levers and a replacement cable (original cable snapped). Both worked fine in the past. Let me know if you have any suggestions. I appreciate your time. -Justin