Search the Community
Showing results for tags 'gio'.
Found 3 results
Hey guys new to the forum I just bought a new pitbike it's a gio 125cc when I bought it the bike wouldn't run without the choke fully on so my guess was the pilot jet just needed to be cleaned out and some fresh fuel should do the trick.... not the case after tearing the carb apart what felt like 100x and not much change in the idle I decided to go order a new carb. I put the new carb on which fit great minus the throttle cable being to long, the bike started right up and with some tuning it ran great with the choke off. I loaded the bike up in my truck to go rip it at a friend's place, I stopped by another buddy's place on the way to show him the new bike, I started it up did a burnout in the bed of my truck shut it off then headed to my friends house to go rip we off loaded the bike went to start it and it wouldn't run without the choke even after being warmed up. So I grabbed by old carb cleaned out the jets again with a torch and compressed air and slapped it back on, it runs way better then in the first place it will start with the choke or some throttle and will continue to run until it's without throttle for more then 5 seconds. I'm at a loss I have no idea what could be causing this any help is welcome! But please read the whole post I know it's long but I wanted to go over the whole situation so it's narrows things down hopefully
Hey all! I have a 2011 Gio X31 250cc that is losing compression gradually. It had amazing compression when it was new...but now it's becoming a tiresome task to kick-start when my electric start is down. It's burning a small amount of oil, but I don't even have to top it up between oil changes (~10 hrs. per change). I'm thinking it just needs a valve adjustment to bring the compression back up. I'm surprised how good this engine has been. I ride it hard and it keeps up with bikes 2-3x the hp and refuses to die! I don't know how to adjust the valves on a 4-stroke, let alone a Chinese one. If any of you know how to adjust the valves on a Gio X31 250cc I would appreciate the help! Do I need to pull the engine for this? Thanks
Hey ya'll! I've been riding my Gio X31 250cc really hard lately and one of the rear linkage bushings went. Now it makes a horrible squeaking noise lol. Does anyone know were I can get replacement bushings or if there are any compatible bushings from name-brand bikes? Thanks, Jordan