Search the Community
Showing results for tags 'impact'.
There is no forum on how to tighten these nuts. Only how to take them off with an impact. I dont want to put an impact on it to tighten it because I want to torque it to correctly with my torque wrench and dont want to &%$#@! anything up. How do you do this without buying the oem honda gear holder tool? Can I buy that tusk clutch holder tool and grab the clutch basket when it joins with the primary gear to stop it from spinning?
Very disappointed!!! I just installed the major backordered Tusk rear (red) 2016 Honda CRF450R hub. Dropped the bike down off stand and went to push it up onto my trailer to go ripping and hear the dreaded click... click... snap... click.. bind... click.... pinch.... click! WTF??? Yep, as it turns out the Tusk hub I received (exact part# 1437260008 that is supposed to fit years 2013-2017) is 1/8" to 5/32" wider than the original stock hub! I uploaded a rather OCD video because I'm trying to prove without a doubt to the vendor that I'm not a moron (well, at least to prove I am right on this issue, the moron part is still debatable... but I digress). Hub is off on sprocket side misaligning the sprockets and causing the chain to bind then release. The brake side seemed ok it wasn't dragging that I could tell, but I didn't dare ride it. I was super focused on the chain/sprocket problem. So, boys, be careful, I ordered another while waiting for this to be resolved, hopefully it fits, but I have my doubts. I had NO ISSUES at all with the front hub, but the rear hub that has been backordered since April 14th that just became restocked slipped through QA by a gross 1/8" error. The video isn't perfect, has focus issues and audio cutout once, so it's not courtroom evidence worthy LOL, but I hope proves my point. I measured this thing six ways from Sunday. Next thing is to delace it and compare side by side, but heading out camping early in the morning so it'll have to wait. Anyone else experience this? I haven't seen any other mention of it, but like I said, this is brand new right off the press, paint still drying, so I may have one of the first ones. Fortunately the vendor is working with me, so I believe a resolution will come, but this ruins my July 4th riding excursions!